Hello everyone!
I have read trough this forum and others but cant find the solution on my own.
First I thought about the battery problem but
when I installed dino-mite i get connection there and my batterys (got 2) seems fine
Today I bought a transcend 2gb sd card (formatted to fat32) but pleo cant find it in dinomite and nothing happends when I turn him on with the sd card with downgrade patch on
Could it be that i need another sd card or is there som serious troble with my pleo?
when I try the windows xp upgrade it says i got 1.1 installed
these are my stats in dino-mite
<=== SENDING COMMAND ===>
stats power
Battery Voltage = 79, Min 79, Max 79 (tenths of a volt)
Battery Temperature = 25, Min 25, Max 25 (degrees C)
Battery Current = 250, Min 243, Max 257 (milliamperes)
Battery sensor value = 87 (% capacity remaining)
Battery sensor direct value = 87, Min 0, Max 87
Battery Voltage A/D = 698, Min 695, Max 699
Battery Temperature A/D = 320, Min 320, Max 320
Battery Current A/D = 35, Min 34, Max 36
Thermistor Resistance = 10195, Min 10189, Max 10198 (ohms)
Battery Internal Resistance = 0, Min 100000, Max 0 (milliohms)
Battery Capacity Consumed = 2 (mAh)
Powered up = true
RTK Adjustments = 0
RTK IK = 0
RTK VB = 0
Power monitor reset early warning = 0 (/LLO)
> <=== SENDING COMMAND ===>
config
Pleo Hardware Configuration:
Hardware ID: 07051101-303B1F27-01002E07-FFFF78FF (01303B78)
Serial Number: 110400466058
Board Revision: 17-8
Board Revision ADC: 536
Build Configuration:
Firmware built for: Pleo
Build type: RELEASE
Pleo main ARM version: 8128 - Mar 19 2008 06:24:52
Pleo head ARM version: 8128 - Mar 19 2008 06:25:46
Pleo PM (DF) version: 8139 - Mar 24 2008 20:32:32
Bootloader version: 7361 - Nov 15 2007 21:34:31
Compiled in: Thumb mode
Resource folders: on
MotorController Configuration:
WARN: low: motion: MotorController0 not configured.
MotorController 0: Version 0
WARN: low: motion: MotorController1 not configured.
MotorController 1: Version 0
WARN: low: motion: MotorController2 not configured.
MotorController 2: Version 0
WARN: low: motion: MotorController3 not configured.
MotorController 3: Version 0
VM Configuration:
Incremental mode: off
Code swapping: false
malloc mode: false
main vm image: 4096
sensors vm image: 3072
auxiliary vm image: 2560
user vm image: 2048
It troubles me to see motorcontroller not configured
can someone help?