Print

[SNDow]

When my PleoRB is performing normal operations, he is working just fine. However when I try to run the ProbeRB program on the microchip, is says "Property Load Fail". Any thoughts on how to fix this?

Tried all of the obvious fixes (redownloading the program, etc.).

[kat]

You could try using StatsRB instead.  It does the same thing as ProbRB just without the talking.  You just put it on the micro sd card adn insert it into the pleo, switch him on let him run for a minute and then switch off and remove ther micro sd card.  Then you can read the information off the card on your computer.  It gives all the same information that you get from ProbeRB.
Hope that helps