Bob the Pleo Forums

Pleo Stuff => Pleo Problems => Topic started by: Chekobraun on July 05, 2019, 03:00:09 PM

Title: My Pleo RB need help!
Post by: Chekobraun on July 05, 2019, 03:00:09 PM

Hello together,
firstly excuse my English.

I have an used Pleo RB. And I have big problems.
-I can read the data’s with the SD Card and after reading he move short….really short.
-When I start the Pleo RB, he doesn’t work…. Nothing, no sound no moving.
-I assembled a new foot battery, and set the clock new at 12 am, but nothing.
What can I do? A new Software update?
I am glad about every feed-back and help of you.

Here are the data’s:
Pleo Property Dump
(Version 1.1 - Pleo RB, Pleo 1.1 or Pleo PM2)

PleoRB Growth Report


Stage 0: Newborn

Growth this stage: 0.4 / 2.1 hours

This stage is 20.0% complete
approximately 1.7 hours till next stage

DNA Attributes (what PleoRB was born with)


Gender: None

Courage: Normal
Temper: Normal
Physical: High
Activeness: High
Intelligence: Low

Health Report (how you are treating your dinosaur)


Mood: 99%
Physical: 71%
Emotion: 56%
Health: 53%
Feed: 44%

Activity: 50%
Obedience: 50%
Skill: 50%

Dinosaur Pheromones (what your Pleo is sending to other Pleos)


WARNING: Pleo pheromone data may be invalid (test again later)
Pleo is sending out Male pheremones
Pleo is sending out a Depressed vibe

Date Stamps

WARNING: this feature is not very useful
Date stamps start when you put in the RTC battery, and will be different than real time

Last Time: around 12:00 on 1/1/2010
PLEO incept date not set (PleoRB is too young)

Best regards

Thomas

Title: Re: My Pleo RB need help!
Post by: mweed on July 08, 2019, 02:17:40 PM

When you first turn the pleo on, what color is the LED on the bottom?

Title: Re: My Pleo RB need help!
Post by: honi on July 19, 2019, 08:39:33 AM

Hallo Thomas,
ich hab eben nach längerer Zeit mal wieder hier im Forum gelesen - leider ist das deutsche Forum ja geschlossen worden. Und so bin ich auf Deinen Post gelangt. Hat sich Dein Pleo-Problem schon gelöst ? Wenn nicht, kannst Du gerne noch mal schreiben - ich schaue nun mal öfter wieder rein.
Pleogreets und en schönes Wochenende
Honi

Title: Re: My Pleo RB need help!
Post by: Chekobraun on December 01, 2019, 12:42:59 PM

Hello,
and thanks for the answers.
I had a different project that why I wasn´t the last few months her.
When i switch the Pleo on, the green light on the bottom is on.
And after them i can`t switch the Pleo off. I must disassemble the battery. It’s the one possibility to switch the Pleo of.
Best regards

Thomas

Title: Re: My Pleo RB need help!
Post by: Chekobraun on December 01, 2019, 01:01:26 PM

Hello,

my Battery tester Shows 8.2 Volt.

Best regards

Thomas

Title: Re: My Pleo RB need help!
Post by: pnhicks on December 02, 2019, 02:20:15 AM

Hi Chekobraun,


It sounds like the firmware is corrupt. The previous owner tried to reset to newborn or used UGOBE firmware other such mistake.  You might be able to write a skit on a sd card to copy the correct files to the Pleo. 


Before doing any other action read all the forum entries on "bricked" Pleo.


Best Regards and good luck restoring your RB.


Peter

Title: Re: My Pleo RB need help!
Post by: Chekobraun on December 02, 2019, 04:20:48 AM

Hello Peter,

Thanks for your answer . I will Check this.

Best regstes Thomas