Bob the Pleo Forums
Pleo Stuff => Pleo Hardware/Software => PDK, Programming, and code => Topic started by: sonra on March 04, 2015, 02:32:46 PM
-
Hi
I am new in this so I need some help
I have a 1g micro SD card that is formated to FAT ( or it should be formatted to FAT32 ? )
I try to run touch_test example from PRBDK after the build i get the build folder and
when I open the folder it incluse a folder named "sounds" and two files
1) sensors.amx
2) touch_test.urf
from my understanding the user guide the only file it is needed is the " touch_test.urf"
I move it to the SD card and insert the card into PLEO power up but nothing happen
PLEO did not wake up !!!!!!
What can be done ???
Regards Doron
-
It can take some time to load when you use a SD card, it might take a full minute or two before the pleo does anything. You are right. All you should need is the .urf file. Be sure it's at the top level of the SD card and not in a folder. You can copy the other files to the SD card as well. They won't hurt anything.
I don't remember, but with the touch test does the pleo wake up, or does it sit there and wait for you to touch the sensor?
-
Hi
Thanks for replay . Try to wait few minutes with no change in problem
the example use the head sensor for playing a sound . Can you try this example if it work with your PLEO rb?
or can you email me a file that is working in your PLEO rb so I can try on mine ?
Are you using a card formatted to FAT ?
Regards Doron
-
Not a great idea to post your email address on a public forum, so I'm going to go ahead and remove that for you. You can send and receive messages via PM and it'll send a copy to your email.
Are you using the PDK for Pleo RB?